My Photo
Location: Cheshire, United Kingdom

Older than I think I am.

Saturday, February 04, 2006

Reamer Instructions

reamer instructions
Originally uploaded by a1scrapmetal.
This Pipe Reamer is manufactured from specially selected Sheffield Steel and the blades are hardened to prevent damage and to give maximum efficiency. The Edge cutters are hollow ground and the Reamer is completely rust proof and the cutters guaranteed not to chip in use.
1. The Reamer must be at its minimum when inserted into the bowl.
2. The Reamer must be inserted at an angle of 90" and maintained at such an angle.
3. Rotate the Reamer in both directions until the blades are cutting smoothly into the carbon wall, using light firm pressure.
4. Continue until the desired thickness of carbon wall is obtained.
5. Great care must be taken where the carbon deposit is lumpy .the Reamer must not be forced but gently rotated in both directions until the lumps are removed.

Do not allow your pipe to become so badly carboned as to prevent insertion of the reamer into the bowl.

Remember that an excessively carboned pipe in brittle and must therefore be reamed with due care.
Made In Great Britain


Blogger michael said...


05 February, 2006  
Blogger hazel said...

YES..isn't it!!
If I didn't know you better I would think you were being rude about my pipe reamer instructions...!?

05 February, 2006  
Blogger michael said...

He he! You do know me very well do 'ee?

16 February, 2006  

Post a Comment

<< Home